== Other Miscellaneous Files == While EMAN2 prefers HDF and JSON files for most tasks, there are a few other formats which are supported and used in specific contexts. === .lst files === LST files and LSTX files originated in EMAN1. They are text files containing a list of image filenames and numbers, which EMAN2 will treat as if they contained actual images. These files follow the following format: {{{ #LSX # warning message # <' ' padding> <' ' padding> <' ' padding> ...}}} Here is an example: {{{ #LSX # This file is in fast LST format. All lines after the next line have exactly the number of characters shown on the nex t line. This MUST be preserved if editing. # 29 0 particles/1075.big.hdf 1 particles/1075.big.hdf 0 particles/1076.big.hdf 1 particles/1076.big.hdf 2 particles/1076.big.hdf }}} Say, for example, that you have 3 image stack files: A.hdf, B.hdf and C.hdf, each containing 500 particles. You wish to combine them into a single stack for running a refinement. An LST file allows you to combine them virtually without actually having to duplicate the images. The LST format is used for the files in the ''sets'' directory, and the ''e2buildsets.py'' command can be used to produce them. While these files can, technically, be edited by hand, every line in the file after the must have exactly the same number of characters. For programmers, there is a class called LSXFile which allows easy reading & writing of these files. === .box files === These files also originated in EMAN1, and are not really used directly by EMAN2, but can be imported/exported. This is a simple text file with a list of particle locations within a micrograph. Here is an example: {{{ 5341 8216 256 256 -3 3269 1876 256 256 -3 3386 2801 256 256 -3 2669 1080 256 256 -3 }}} There are 5 columns. The first 2 are the x/y coordinates of the lower left corner of the box. The next 2 are the box size in X and Y (normally the same). The fifth number is a 'mode', and isn't always present. This value is normally used to identify filament boxes (with a starting and ending coordinate on paired lines). Just use -3 for normal single particle box files. Note that since the coordinate is the lower left corner of the box, if you want to change the box size, you also need to adjust the box coordinates, or the center of the box will shift.